Recent content by BanditGTP

Sold. Hopefully one day I’ll pick up a Yukon or Tahoe and be a member again. Actually my wife is driving a 2016 Acadia so I may still be hanging around. Thanks everyone for all of the help I’ve gotten over the years.

Well unfortunately I haven't had any luck selling my Envoy and the best price I got from scrap places is $500. I'd rather see it go to someone that could use it for parts instead of a scrap/recycler place. If I don't get any takers over the next few days, it'll be heading off to a scrap yard.

Dropping the price one last time to $600 before it ends up going to a junk yard. I started it a few days ago and the engine was running fine. If this damn transmission problem didn’t come up, I wouldn’t have any doubt I would still be putting lots of miles on it. Can one of the mods erase the...

So....I got the new truck (work van:frown:) so now the lack of parking spaces is an everyday topic in the house. Dropping the price to $800.

Just reduced the price. It needs to go since I’m planning to get another truck soon and I don’t have enough room for all the cars in the family. As of now, I’m still looking to sell it as a one piece but I may be up to selling some parts if it comes down to going to a scrapyard with it. I’ll...

Thanks for the suggestion Tollkeeper. I checked the fluid level when this all happened and the level looked fine. I recently changed the filter and fluid using the process I found by disconnecting the line from the radiator and then running the engine to drain the fluid. I went through 3...

The time has finally come to part ways with my Envoy. A few months ago as I was getting up to speed on the highway entrance ramp, I lost all gears. I had it towed back home and it has sat there since. I haven't taken it to a shop to check out just because I'm not looking to put any money into it...

I had a chance today to test the pump using the transmission line to see if the fluid was circulating. Unfortunately no significant amount was draining out. I just did this same procedure recently when I changed the fluid and filter so I know how much should be coming out and it wasn't the same...

Thanks. That’s what I was afraid of. By any chance do you know if it’s possible to drop the tranny without a lift? I swapped out the tranny on my 04 Grand Prix in my garage without a lift. I dropped it out the bottom. I really don’t think I want to go this route though and also don’t think my...

Thanks Blckshdw..I guess I'm going to test the pump situation like I mentioned and then possibly drop the pan to see if there's pieces in there. Now I just need to wait for a nicer day since I've come up with Coronavirus projects to keep me busy in my garage which means I have no room for the...

Hi guys. I can't seem to catch a break. I've been putting some miles on my truck (03 GMC Envoy XL) again after a few past problems and while driving around 30-40 mph, I got on an entrance ramp onto the parkway and when I stepped on the accelerator, it felt like I was in neutral. I stepped harder...

I looked into something I came across the other day while trying to troubleshoot my transmission problem on my 03 Envoy XL. This is a video of the passenger side CV axle going into the Axle Disconnect. I originally thought it was not fully seated but it feels like the internal retaining clip is...

I was able to reach it with laying on some cardboard and reaching under by the driver's door. I was able to push it back in place and still drive it for a few days before I was able to replace it. If you do drive it home, make sure it's definitely in park before you get out. It really surprised...

Just wanted to update on truck. I've put 1300 miles on it since the fluid, filter and solenoid change and so far so good. I did notice 2x it almost seemed like the trans was possibly slipping when I was rolling to a stop but then got back on the gas quickly. I'm not sure if I caught it exactly...

It was dark but not sludge. The bottom of the pan had a shine to it that I think would be a sign of normal wear. I followed the process I found on here that linked to a YouTube video of disconnecting the line from the trans cooler and using the running engine to flush through the fluid. After...