Recent content by Jon Blaze

I replaced my fan clutch because of the roaring. 2006 trailblazer 4/4 I6 67000 miles Owned since new this is my first fan clutch also replaced water pump and thermostat Water pump noise and small leak thermostat due to only warming to 165 degrees F. My question is do I have to do a relearn...

Also at the same time if i replace the uca or the lca should i replace the bolts to the frame

06 trailblazer 4/4 4.2 engine 67000 miles no front end work done except for alignment every year with state inspection Now i watch may03lt video on bumps and clunks and saw there was play in the ball joint and uca bushings. I checked my lower ball joint and there is little play in my lower ball...

Just a tip you can replace the motor mounts on i6 trailblazer a lot easier by removing the 3 of the 4 bolts that mount the motor mounts to the engine block and save yourself a ton of work replaced both my mounts in under 2 hours

Yes then go under to pull bolt from bottom of the mount then go thru the wheel well close to the cab at the ground mount. Use a 18 mm wrench take off top nut on mount then pull mount out thru top between master cylinder and intake After you remove the vac hose to brake booster. Slip mount back...

I check the trans mount it look good very little to no movement. I was out there for 4 hours messing around with the mount on the passenger side. Now i know you dont need to take the mount off the frame. Pull 3 of the 4 bolts that hold the mount to the block and it moves the mount right out of...

Ok just removed passenger side mount and no cracks or melted rubber. I did shake it and it sound like there is a rock inside it. I ordered new mounts and i will check them when they come in.

They move the same as the other trailblazer as from what i can see. Is there away to check them besides having someone in the driver seat stabing the gas?

I own 2 trailblazers 06 4/4 4.2 one has 76000 miles on the other has 59000 miles. The one with 76000 miles on has a vibration in park-neutral-drive rpms do not go erratic. I put in reverse and no vibration. I had someone inside and put it in gear and stab the throttle on both of them engines...

No none I just replaced plugs ac delco and also replaced all 6 coil packs with ac delco then cleaned tb and pulled both fuses before I started any work on it.

Im having the same problem 06 trailblazer 4/4 i6 76000 miles In park and neutral same vibration no better or worse put in drive still there Put in reverse and it goes away I own 2 of the same vehicles same year same model just different mileage no problems with the other one. I checked the...

I had the same issue pulled the bottom part of the seat out and the seat heater wire was broken in 3 different spots. The wrap on the seat heat splits into 2 pcs. i solder the spots then t put tape around the spots and hot glued the pcs. back together and it worked. My seat heat wires broke...

Ok today i pulled the battery out Checked the terminals under the rubber boots no cor. wires are tight check alt wires all good followed ground to strut tower there is cor. cleaned it off sandpapered it and some vas. then put a load test on new battery started out at 12.6 tested went to 10.5...

I tested some stuff went for a ride came back checked charging system 13.7/13.8 turned on everything heated seats blower on high with defroster high beams interior lights. Started out at 13.3/13.6 then rev up engine to 1500 volts dropped to 12.9 let off throtle dropped to 12.4 then went up to...

I used a wrench on both sides they are good