Recent content by Nova63

Illogic, I have the receipt at my Summit log in page, but It doesnt matter due to the horrific shipping price from USA to Sweden. Ill have to ship it back to Summit, and its not worth it. Ill talk to the owner of this car and he'll decide what to do. Stick with 2 wheel drive vehicle or bolt on a...

Just done with ohm test on encoder motor, I checked the orange and the tan, wire (they are not the same color at the dorman unit but anyway, i was looking at the stock harness) Its the two in the middle. I got NOTHING! the ohm meter didnt respond at all. I checked it on both ends on a lose wire...

I will take a reading with my ohm meter between the 2 pins in the bottom center of the connector. Measure between orange and tan on the cables going into the encoder motor. The resistance should be between 15-25 ohm. If its not between these values the encoder motor is bad. Is this right...

Or do you mean that I should take the reading from the connector on the harness going forward from the solenoid motor to the TCCM? Matt

IllogicTC, Thank you very much!! So you mean there should be 15-25 ohms measured between the two "bottom" middle pins next to eachother at the connector. Between the orange and tan wire going inside the solenoid motor? If this value is lower or much higher the issue is inside the motor? Thanks Matt

Yes, it can be the switch but I doubt it... I have lights on for a sec when turning the key, it it was the switch I assume it the lights would be dead all the time, but im not sure. It was acting exact the same way when the solenoid motor was fried, but I assume the new one should last more than...

Roadie, Maybe you are right about the flaky wiring, but I was under the car just minutes ago and unbolted the encoder motor to make sure this was not a stuck transfer case issue. Same thing with the motor lose in my hand, no click nothing in the solenoid when turning the switch. I checked the...

Roadie, Last time the issue was; Transmission was stuck in low when I got the car. The switch blinked for a sec or two when ign on, then again for a sec or two when starting the engine. I had a buddy in the car playing with the switch while i was under the vehicle messing with the wires going...

Year is 2002, No I dont have the schematics, its the 7 pin type connector to the encoder motor. Im not sure which ones that should have current when engaging the switch. The wiring seems to be roated forward above the transfer case and transmission. Do you know where the other connector is...

When the transfer case motor was dead last time it throws the code C0327

Hi guys, About 6 months ago I had an issue with this trailblazer. It turned out to be the transfer case motor. I purchased a new Dorman unit from Summit Racing and replaced the old one and everything worked great. Now I have the same issue again!! Indicators at the switch blink when I turn the...

Its a 2002 TB, I didnt know everyone had the NP226. Thats why I asked. Thanks Matt

Roadie, you seem to know everything about these cars, can you look at the pic and tell if this is the New Process 226 Transfer case, RPO code NP8 I found the 7 pin Dorman Transfer Case Motors 600-903 At summitracing, and just want to make sure I get the right part...

Thanks Roadie, appreciate your help!!! I will order the Dorman unit from Summit and hope for the best :) Matt

What do ya think guys, will it hurt anything using the car with the 7 pin contact to the encoder motor disconnected?? Matt