Recent content by S13Hitman

Brother! Thank you. So now that I'm digging through the wire diagram I see how many things are intertwined with the splice packs, AKA splice pack Network. I had issues with my ABS light going on and off but no actual issues with the hardware or mechanically. Seems like it may have caused other...

So finally digging into this today I see that splice pack 205 goes to splice pack 206, is 206 the bigger block of wires underneath the dash? I found 205, just need to know where pack 206 is located. Dang diagram doesn't say. Going to poke around to see if I can find it. I have continuity...

Thank you!!

I have the FSM already. I just can't find the circuit

2002 4.2l I don't mind chasing some wires down but I cannot find the diagram for this circuit. I appreciate your assistance very much.

Yes the scanner does power up and runs the test but states not able to connect to ECM/PCM

Trying to diagnose why the dummy light is on but 2 different OBD2 scanners are not connecting to the ECM. I tried using my Bluetooth scanner which has always worked fine and then purchased a wired one from Amazon. Yes, the #13 fuse (cigar) tested good. I have continuity from the OBD2...

Solved. Tried 2 parts stores with different sized fittings, no luck. Had a buddy bring me back to the junkyard and snagged the aftermarket fittings. New rad is in and 0 leaks.

Headsup... My quick disconnect does not seem to want to slide onto the metal barb sticking out of the heater core. I checked with AutoZone and another store, I have the correct connector but damn my luck right now. I improvised and just slide the rubber hose (with the metal crimp removed)...

I have a feeling that I might need to go back to that yard to get those fittings but it's an hour away and I'll have to ask a friend for a favor during this crazy virus scare. So it's not ideal but may be the only option. Hopefully nobody trashes the fittings prior.

I almost purchased those ACDelco $18 set of plugs from Amazon, Ebay has them as well. I knew they had to be fake until I searched this great forum... Damn, I was right and can't save any money.

I just ordered Dorman 800619 from Amazon but shipping may be delayed. Going to try Autozone when I can get a ride there as well. And yes Mooseman, I know your right. I had tried removing the clips at the junkyard and cut my hand with a little pick. At that point, I decided to go for the nut...

Thanks Mooseman, I did remove the other bits and have the replacement part. I've tried to remove the stuck plastic a few times, it's not budging. I'll get a hose clamp and hope that works okay. The nipple has a ribbed end so just using a hose clamp should be okay.

Here is the hardline NOT going into the NEW rad:

Pulled a radiator from a 2004 TB at the junkyard. I pulled one that looked as if it had been replaced, plastic still shiny. It's going into my 02 TB. Looks identical and it is, except for where the trans oil cooler lines go in. The screw insert is slightly smaller in the trans cooler. I...